Ivoclar Vivadent Te-Econom Bond

• One-bottle, one-layer adhesive.
• High bond strengths.
• Minimal evaporation of the solvent (alcohol).
• For direct light-curing restorations.

Te-Econom Bond is a single-component bonding agent for enamel and dentin bonding in conjunction with the total-etch technique.

 INDICATIONS-

• Direct light-curing restorations.

 ADVANTAGES- 

• One-bottle, one layer adhesive.
• High bond strengths.
• Minimal evaporation of the solvent.

COMPOSITION-

• Consists of HEMA, di- and mono methacrylates, inorganic fillers, initiators, and stabilizers in an alcohol solution.

STORAGE TEMPERATURE 2–28 °C (36–82 °F)

• 1 x 5g Bottle

STEPS - 

• Select the shade. For facilitated access to the treatment field, the flexible and patient-friendly mouth opener OptraGate can be used.
• Establish sufficient isolation, preferably with a rubber dam (complete isolation is ensured with, for example, the anatomically shaped OptraDam Plus).
• Prepare the cavity according to the requirements of the adhesive technique.
• Clean the cavity with water spray.
• Air-dry the cavity.
• Apply a pulp protector (calcium hydroxide) if needed; only cover areas close to the pulp and subsequently apply a pressure-resistant cement (e.g. Vivaglass Liner).
• Place a matrix (e.g. the selectively thinned OptraMatrix) and an interdental wedge, if required.
• Apply Eco-Etch on the enamel and then on dentin and allow a reaction time of 30 seconds on enamel and 15 seconds on dentin. After that, thoroughly rinse with water spray and dry the tooth surfaces with oil-free compressed air. Avoid dehydrating the dentin.
• Apply a generous amount of Te-Econom Bond on enamel and dentin, using the enclosed applicator brush. Brush the material gently into the dentin for 10 s. Next, evaporate any remaining solvent with a slow stream of air. Lightcure the adhesive according to the curing time recommendations below. Ensure complete coverage of the preparation surface.
• Apply Te-Econom Flow in layers of a max. of 2 mm and light cure according to the curing recommendations below. Apply Te-Econom Plus in layers of max. 2 mm and adapt/contour the material with a suitable instrument (e.g. OptraSculpt). The OptraContact instrument can be used to selectively position high-quality proximal contacts. Polymerize each layer individually according to the table below. Hold the light emission window as closely as possible to the surface of the restorative material.
• Finish the restoration with suitable finishers or fine diamonds. Subsequently, check the occlusion. Polish with silicone polishers (e.g. OptraPol Next Generation).