Cerkamed Rubber-dam Liquid Mega Pack

Light-cured Rubber-dam Liquid

Suitable for occlusal stamp technique

COMPOSITION

• Urethane resins
• Inorganic fillers

INDICATIONS

• Gingiva protection during dental treatments: whitening, etching, microabrasion, sandblasting etc
• Used for sealing rubberdam

Features:

• New quality of work
• Perfect protection of soft tissues
• Wide range of use

Key Specifications:

• • COMPOSITION

    • Urethane resins
      
    • Inorganic fillers

Packaging:

• • 4 × 1.2ml Syringes
  • Disposable applicators

Directions To Use:

• • For gingiva protection during dental treatments:

    • Step 1

    Clean and dry gingiva. With the use of appropriate instruments (e.g. buccal and labial retractor) immobilize lips and a tongue in order to avoid contact with the liquid.

    • Step 2

    Remove the syringe lock and install the included disposable applicator.

    • Step 3

    Apply RUBBER-DAM LIQUID along the application area 4-6 mm wide and approximately 1.5-2 mm thick, at the same time overseeing the amount of the preparation being applied.

    • Step 4

    If possible, squeeze RUBBER-DAM LIQUID through interdental space.

    • Step 5

    Cure the preparation for 20-30 seconds using polymerization lamp. Conduct the curing process evenly in a scanning motion. Then, proceed the dental treatment.

    • Step 6

    After the treatment is completed, lift off polymerized RUBBER-DAM LIQUID using the instrument on the either side and remove.

    In order to seal rubber dam:

    • Step 1

    Isolate the working area (tooth, teeth, alveolus) using RUBBER-DAM.

    • Step 2

    In order to seal rubber dam, apply the layer of the liquid on the edge of the gingiva and the rubber dam.

    • Step 3

    Cure the preparation for 20-30 seconds using a light cure unit . Conduct the curing process evenly in a scanning motion. Then, proceed the dental treatment.

    • Step 4

    After the treatment is completed, lift off polymerized RUBBER-DAM LIQUID using the instrument on either side and remove.

    • Step 5

    Immediately after the use withdraw the syringe plunger and place the original cap on the container to avoid polymerization of the product in the syringe.

    • Step 6

    The product is intended for reusing, while the applicator is designed for disposable use. Reusing the applicator may cause the hazard of re-infection.