3M Espe Retraction Capsule

Gingival Retraction Material

Features:

• Viscosity:Heavy Body
• The extra fine tip fits directly into the sulcus.
• Enables a clean, dry sulcus and robust hemostasis.
• Hygienic unit-dose capsule.
• Versus dental retraction cords:
• Convenient and time-saving retraction process: Up to 50% faster.
• Lower risk of hemorrhage.
• Gentle on tissue for improved patient comfort.
• Versus competing pastes:
• Easy access into the sulcus.
• Better interproximal access due to capsule’s extra-fine tip.
• Compatible with most composite dispensers.

Key Specifications:

PRECAUTIONS:

The product must not be used in patients suffering from a diseased periodontium, open furcations or exposed bone.

FREQUENTLY ASKED QUESTIONS:

For how long can the paste be left in the sulcus?

• Typically, the paste should be left in the sulcus for a minimum of 2 minutes to achieve good retraction results. If a hemostatic device is applied too long it may exert unwanted negative effects on the tissue health. Therefore, the hemostatic retraction paste must be rinsed off completely.

How long can one store the capsule outside of the blister?

• The capsule must be taken out of the blister immediately prior to application. It should not be stored outside the blister.

How many teeth can be treated with one capsule?

• The content of one unit-dose capsule is sufficient to treat up to 3 teeth. The capsules are for single use and must not be used on more than one patient.

What is the orientation ring for?

• The orientation ring corresponds in size and position to the perio probe. It is a feature for more precise and easy intraoral handling.

Why is there a lower risk of bleeding/post-hemorrhage than with cords?

• Cords consist of small fibers that may be incorporated in the coagulum. When the cord is removed, the wound might be opened again. The paste is washed off by air-water spray and suction, resulting in a clean and dry sulcus area.

How can one judge if the retraction effect is sufficient?

• The preparation margin should be clearly visible in the impression. The amount of excessive impression material (“flash”) that covers sulcular areas below the preparation margin is not important.

Does the 3M™ ESPE™ Retraction Capsule influence the setting of impression materials?

• As with all astringents, the 3M ESPE astringent retraction paste may inhibit the setting of A-silicones (VPS) and Polyethers. The paste must be completely rinsed off with air-water spray and suction prior to impression taking.

Directions To Use :

INSTRUCTIONS TO USE:

1) Remove a retraction capsule from the blister and insert into dispenser (fits into most composite dispensers). Extrude a small amount of paste and discard.

2) Insert retraction capsule tip into the sulcus.

3) Slowly and steadily, inject astringent retraction paste into sulcus. Completely fill the sulcus.

4) OPTIONAL: PROCEDURE WITH CORDS. For more gingival deflection, the astringent retraction paste can be used in combination with retraction cords.

5) Leave astringent retraction paste on for a minimum of 2 minutes.

6) Completely remove astringent retraction paste with air-water spray and suction.