Ivoclar Te-Econom Flow

• Features :

• • Broad indication spectrum
  • Optimal handling
  • Easy access to even the smallest cavities
  • Accurate and economic application
  • Available in shades A2 and A3

  Description

  Light-curing, radiopaque, flowable composite

  Indications

  • Restorative therapy for mini-cavities of all types
  • Small posterior restorations (Classes I, II)
  • Classes III, IV, V restorations
  • Preventive resin restorations

  Key Specifications

  Compositions

  Consists of dimethacrylates (37 % wt), inorganic fillers (62 % wt or 38 % vol) with a particle size between 0.04 and 7 µm, initiators, stabilizers and pigments (1 % wt).

  Packaging

  • 1 x 2gm syringe

  Direction to Use

  • Select the shade. For facilitated access to the treatment field, the flexible and patient-friendly mouth opener OptraGate can be used.
  • Establish sufficient isolation, preferably with a rubber dam (complete isolation is ensured with, for example, the anatomically shaped OptraDam Plus).
  • Prepare the cavity according to the requirements of the adhesive technique.
  • Clean the cavity with water spray.
  • Air dry the cavity.
  • Apply a pulp protector (calcium hydroxide) if needed; only cover areas close to the pulp and subsequently apply a pressureresistant cement (e.g. Vivaglass Liner).
  • Place a matrix (e.g. the selectively thinned OptraMatrix) and an interdental wedge, if required.
  • Apply Eco-Etch on the enamel and then on dentin and allow a reaction time of 30 seconds on enamel and 15 seconds on dentin. After that, thoroughly rinse with water spray and dry the tooth surfaces with oil-free compressed air. Avoid dehydrating the dentin.
  • Apply a generous amount of Te-Econom Bond on enamel and dentin, using the enclosed applicator brush. Brush the material gently into the dentin for 10 s. Next, evaporate any remaining solvent with a slow stream of air. Lightcure the adhesive according to the curing time recommendations below. Ensure complete coverage of the preparation surface.
  • Apply Te-Econom Flow in layers of a max. of 2 mm and light cure according to the curing recommendations below. Apply Te-Econom Plus in layers of max. 2 mm and adapt/contour the material with a suitable instrument (e.g. OptraSculpt). The OptraContact instrument can be used to selectively position high-quality proximal contacts. Polymerize each layer individually according to the table below. Hold the light emission window as closely as possible to the surface of the restorative material.
  • Finish the restoration with suitable finishers or fine diamonds. Subsequently, check the occlusion. Polish with silicone polishers (e.g. OptraPol Next Generation).